Mineraluxe Cleanse and Drain

Renew Your Hot Tub with Mineralux Solutions

Are you looking to make sure your hot tub is as clean and fresh as can be? Look no further than Mineralux! Our Cleanse & Drain solution helps eliminate organic waste contamination in hot tub plumbing, giving you a brand-new spa experience without the need for draining.

Simply apply the product 24 hours prior to draining, and you’ll be ready for a new Mineralux system – no more need for treatments like this! With Mineralux on your side, you can experience the best hot tubing around.

Don’t let grime and gunk get in the way of your relaxation time. Give yourself the spa experience you deserve with Cleanse & Drain by Mineralux!

Enjoy clean hot tubbing with Mineralux today!

quicksteps 

Why:

• Cleanse & Drain is recommended for use in any hot tub prior to going onto the Mineraluxe system for the 1st time
• Cleanse & Drain is not normally needed once a hot tub is on the Mineraluxe system
• Traditional water care systems are not effective in preventing biofilm, greases, residues, scale deposits, etc. from forming on surfaces
• Cleanse & Drain cleans plumbing and other hidden surfaces of these deposits
• Cleanse & Drain releases and digests
• All natural blend of;
  • Powerful surfactants – ‘release’
  • concentrated enzymes – ‘digest’
• Nature’s way of biodegrading organics 
  • Body oils, greases, cosmetics
  • Biofilm
  • Organic accumulations
• End result is water and CO2 Also cleans scum-line and other hot tub surfaces exposed to the water
  • Safe to pump away to drain or lawn

When:

• Prior to draining
• Time allows product to release and digest more thoroughly. Allow to soak;
  • 12 – 24 hours in routine procedure
  • 24 – 48 hours when;
    • Cleaning up biofilm
    • After other problems
      • Heavy foaming
      • Bad odours
      • Visible organic accumulations

How Much:

• Use 750 ml per application

Note: Water may not look good after application

How: 

• Maintain heated temperature
• Remove filter cartridge(s)
• Apply product directly to water
• Operate pump 3 – 5 times through soaking process (run for 5 minutes each time) with;Operating pump periodically helps release attached waste for better cleaning
  • Diverter valves neutral
  • All jets operational (air off)
  • Waterfalls and other features operating
• Foaming will occur – turn pump on and off to control the amount of foam

Tubs that start on Mineraluxe without performing a Cleanse & Drain treatment may experience a visible flushing of waste due to the powerful ‘repel’ feature of Mineraluxe.